Thinkpads Forum

It seems like Lenovo is still trying to piss us off with unwanted changes. The new X1C12 is going to move the fingerprint sensor once again. From I think Gen 9 on the sensor was in the power button, like in many phones (from a cutout in the palmrest previously), but they now moved it to one of the keys in the keyboard, with is the most stupid thing I've ever heard. Well, maybe not from an OEM point of view, since they will probably save a few cables, a sub-card and some labor to connect the power button. I believe they relocated the power button to the side.

Why is it stupid? Because every time you replace the keyboard you'll have to pay for a fingerprint sensor too. It's like with motherboards: every time you replace a planar you have to ditch a processor, some memory and the wireless card. So much for saving the planet...

But above all, because they keep stealing keyboard keys. Since there is no more "print screen" key, there is probably a new keyboard combination / function to learn.

Also, they finally switched the Ctrl and Fn keys.



But above all, Lenovo is still trying to kill the Trackpoint. They know that'd be the last nail in the coffin (for hardcore Thinkpad fans of course, there will always be someone buying their products Trackpoint or not) so they, AT LEAST, decided to give you the option. So I wasn't mistaken: the X1C12 will come without physical Trackpoint buttons (clickpad) in some version. BUT that's going to be optional because there will be a version with the buttons.

So there you have it: now the Trackpoint buttons are going to be optional.

To be fair, I've heard a lot of people complain about the touchpad (people who obviously has never used the Trackpoint) and Lenovo is just wanting to please that crowd.

The trackpoint buttons have been compromised since they got flattened and removed their hinged nature.

On the bright side, it seems like Lenovo did some serious re-design to the cooling system.

With the heat pipe installed that way, it essentially doubles the thermal transfer from the chip
(albeit the surface area for dissipation isn't doubled that way) and reduces thermal concentration.

It doesn't seem that crazy now to run 28W chips on an X1.

Other problems aside - I'm sad to see the control and function keys switched. I've really come to prefer the Lenovo/IBM way in that regard - much more ergonomic to not have to stretch your finger as far when you need to hit it. You end up using control far more often than function, it makes sense to have it closer to where your fingers are in my opinion.

Ctrl and Fn keys appear to be the same size, shouldn't be too much of a problem to swap the key caps.
Either also swap them in BIOS (if option still available) or use other keyboard programs.

I get that's possible and all, but the labels would still trip me up. I'd have to relabel them.

I've been using my X1 G12 now for about 1-1/2 years and it has been performing fine but the black coating is wearing off the edges of the palmrest. I'm more than mildly annoyed. Any suggestions?

Respray palmrest DIY or by the nearest bodyshop?

New palmrest, e.g.:
https://www.amazon.com/Laptop-PalmRest- ... B0DJXT3Y4M

Thanks RBS. Replacing the keyboard frame makes the most sense but I dread the tear-down required to replace that part.

Maybe this helps: https://support.lenovo.com/om/en/solutions/ht515962

Thanks again RBS. I just finished viewing a few of the videos and reading the HMM. The computer needs to be gutted, which I did for my Gen 5 and swore that I would never do it again. How I long for the good old days when the bottom of the computer was the base instead of the keyboard frame.

Or get a 4-part vinyl cover set for it: https://www.ebay.com/itm/326778643549

I used that option on a heavily scratched X1 carbon several years ago and found it to be very successful. IIRC, I found my skin in eBay.